Where can I get Valve Cover Bolts for My 94 Civic Vtech?

Let’s learn where can I get Valve Cover Bolts for My 94 Civic Vtech. The most accurate or helpful solution is served by Yahoo! Answers.

There are ten answers to this question.

Best solution

Where Can I Get Valve Cover Bolts for My 94 Honda Civic vtech?

I need to replace two bolts on my valve cover and i need to know where i can get these bolts? i am gonna try a junkyard..but i dont want to go to honda because they are too expensive ...show more

Answer:

honda dealership or online at hondaautomotiveparts.com, slhondaparts.com, or hondapartscheap.com (look...

FDJ54QYTQFUNP6C2YQXBXW2BL4 at Yahoo! Answers Mark as irrelevant Marked as irrelevant Undo

Other solutions

Where can i get or fix my valve cover for my 93 mitsubishi eclipse 1.8 gs its cracked?

i just bought a 93 mitsubishi eclipse it had a small easy fix oil leak that only cost 10 dollars i had to replace the valve cover gasket I took off the valve cover and replaced the gasket I than was just screwing in the last 2 top bolts on the valve...

Answer:

If it is plastic then take it to someone that does plastic welding & have them repair it, if it...

Bluey at Yahoo! Answers Mark as irrelevant Marked as irrelevant Undo

94 mustang has quiet knock driver side valve cover?

i believe i have a knock under valve cover pass side towards front of car. someone did a swap and nothings right on it. i bucks alot when you hit the gas hard it like pops a little in throtle body wont rev high but when i barly hit it it revs alot better...

Answer:

probably a combination of a few things but the tapping could be a bad lifter or the valve train is not...

jr at Yahoo! Answers Mark as irrelevant Marked as irrelevant Undo

96 Contour 2.0 4 cylinder The valve cover didn't want to come off once the bolts had been removed. I was afraid to apply to much force for fear of damaging the cover Do these get stuck?

Answer:

They do get stuck, but not really hard. There is only a thin rubber gasket underneath. suspect you don...

wiki.answers.com Mark as irrelevant Marked as irrelevant Undo

I have a 1998 civic ex. when I went to get parts they tell me it is a D16Y8 but it says on D16Y7 on the engine. There is also no Vtech inscription anywhere on the engine or valve cover? is it possible that it is acutally a D16Y7 in this car?

Answer:

Yes, it is very possible, this engine (D16Y7) is a non-VTEC engine. The D16Y8 is VTEC. This car could...

gordon at Answerbag.com Mark as irrelevant Marked as irrelevant Undo

How do you get to the left side bottom valve cover bolts on 2003 Lincoln ls v8?

Answer:

Hello, remove the plastic coverings around the wiper area and the part that is mounted to the strut...

wiki.answers.com Mark as irrelevant Marked as irrelevant Undo

What size heli coil kit should i get for my Honda accord with VTEC engine if the five bolts holding the valve cover on the engine are stripped

Answer:

Check out http://www.cartools.com/Helicoil_Thread_Repair.htm. They have different kits, and may be able...

Anonymous at ChaCha Mark as irrelevant Marked as irrelevant Undo

What should I do about my valve cover?

I went to the mechanic 2 days ago, and got some general maintenance done to my vehicle. I had my CV axles replaces, my spark plugs, and the high mileage hating valve cover gasket. Well my vehicle has been sitting for two days so of course I wouldn't...

Answer:

you will have a hard time proving he did it to your car. he can always lie and say he never even saw...

Jonathon Harris at Yahoo! Answers Mark as irrelevant Marked as irrelevant Undo

My 1998 Nissan Quest will not crank after replacing the front valve cover gasket. What could be wrong?

I had to move the distributor out of the way to get to one of the valve cover bolts. I made sure not to remove any of the plugs from the cap. Did the negative battery connection need to be disconnected before taking and moving the distributor out of...

Answer:

You mean it cranks but don't start. Check the connectors going to the distributor.

Yahoo! Answers Mark as irrelevant Marked as irrelevant Undo

What size Heli-Coils should i get?

I have a 1994 Honda Accord with a VTEC engine. There are 5 bolts holding the valve cover on. They are a carriage style with rubber gromet/gasket at the head of the bolt. The Engine block threads are stripped/missing. What size Heli-Coil kit should i...

Answer:

Just take the bolt with you to the auto parts store and the counter person will give you the correct...

blahblah... at Yahoo! Answers Mark as irrelevant Marked as irrelevant Undo

Related Q & A:

Where can I get empty nasal spray bottles?Best solution by ebay.com
How and where can I get my work history?Best solution by Yahoo! Answers
Where can i get photos made into pop art or caricatures?Best solution by Yahoo! Answers
Where can I find sample cover letters for a leasing agent?Best solution by Yahoo! Answers
Where can I get get a job?Best solution by Yahoo! Answers

Just Added Q & A:

How many active mobile subscribers are there in China?Best solution by Quora
How to find the right vacation?Best solution by bookit.com
How To Make Your Own Primer?Best solution by thekrazycouponlady.com
How do you get the domain & range?Best solution by ChaCha
How do you open pop up blockers?Best solution by Yahoo! Answers

For every problem there is a solution! Proved by Solucija.

Got an issue and looking for advice?
Ask Solucija to search every corner of the Web for help.
Get workable solutions and helpful tips in a moment.

Just ask Solucija about an issue you face and immediately get a list of ready solutions, answers and tips from other Internet users. We always provide the most suitable and complete answer to your question at the top, along with a few good alternatives below.