Where can I get Valve Cover Bolts for My 94 Civic Vtech?

My 1998 Nissan Quest will not crank after replacing the front valve cover gasket. What could be wrong?

  • I had to move the distributor out of the way to get to one of the valve cover bolts. I made sure not to remove any of the plugs from the cap. Did the negative battery connection need to be disconnected before taking and moving the distributor out of the way? With both the new gasket in cover and bolted in and the distributor back in place, it will not crank. It will turn over but not crank. What might I have done different?

  • Answer:

    You mean it cranks but don't start. Check the connectors going to the distributor.

Yahoo! Answers Visit the source

Was this solution helpful to you?

Other answers

turning over and cranking are the same, if it wont fire theres a good chance you may have split a wire going to the distributor, pull the cap and check inside, also check the wires for cracking going into the dist.

ron

Related Q & A:

Just Added Q & A:

Find solution

For every problem there is a solution! Proved by Solucija.

  • Got an issue and looking for advice?

  • Ask Solucija to search every corner of the Web for help.

  • Get workable solutions and helpful tips in a moment.

Just ask Solucija about an issue you face and immediately get a list of ready solutions, answers and tips from other Internet users. We always provide the most suitable and complete answer to your question at the top, along with a few good alternatives below.