What would be the best amp for this?
Let’s learn what would be the best amp for this. The most accurate or helpful solution is served by Yahoo! Answers.
There are ten answers to this question.
Best solution
I dont want to spend too much money on a amp i and would like to purchase a D class amp though. I plan on getting the amp off ebay also. I have a lanzar 4 channel 1000 watt amp pushing 1 12 inch L7 but i plan on selling all that. and wanted to know what...
Answer:
Sorry Lanzar arent good amp. I'd get a Kicker,PPI or Hifonics amp. Now that should sound good..
Josh R at Yahoo! Answers Mark as irrelevant Undo
Other solutions
I currently have a SVC MXS1004 MTX 10" sub, it maxes at 400w RMS @ 4OHMS. I have run a tc3001 to it and it overheated the amp I have run a tc4001 to it and it also overheated it I have run a tc6001 to it and the amp was ok, however that amp is now...
Answer:
Lose the mtx and get some kicker, been using their products for years, never had any problems. go to...
JM at Yahoo! Answers Mark as irrelevant Undo
Ok im looking for theee best sound quality amp out there. Im looking to buy around 1k-1.5k watt amp. I want to buy the best amp I could buy to power my subs. And what should I get (1) ...show more
Answer:
http://mosconi-america.com/ http://www.focal.com/en/43-car-audio-sys... http://www.sundownaudio.com...
RL5NVCSYQPNPZO6T6ANESHTTEQ at Yahoo! Answers Mark as irrelevant Undo
i plan on getting (2) 15" kicker L7's and want an amp that is a perfect match RMS wise. i cant seem to figure out what amp will go best with the 4 ohm DVC's. i was told that a kicker zx1500.1 would go well with them, but when wired it will be at...
Answer:
for those subs there i would get the kicker ZX2500.1 amp, i gotta buddy that has those subs and that...
randizza... at Yahoo! Answers Mark as irrelevant Undo
I am installing an aftermarket car stereo consisting of 4 aftermarket Polk Audio Db571 speakers and 2 12'' Diamond audio subs. I have a Boss Audio CX 600 4 channel amplifier for the 4 speakers and an American Bass amplifier for the subs. The receiver...
Answer:
either option will basically be the same most likely... you didnt list the AB amp model # but most amps...
Chris at Yahoo! Answers Mark as irrelevant Undo
So i have two 12 inch Kenwood KFC-W3011 4Ohm subs and was wondering what type of mono amp i should get for them. My old amp was a Soundstorm 2500 and that one busted on me and now im in need of a new one. Right now i've been looking at a Hifonics BXI...
Answer:
i would get the kenwood kac-9104d its meant for them subwoofers http://cgi.ebay.com/2009-KENWOOD-KAC...
Omar at Yahoo! Answers Mark as irrelevant Undo
I have a 1000 watt amp and a pair of 700W speakers. The output of the amp is either Speakon or Bananna. The input of the speaker is Speakon or 1/4" plug. Can I only 1 run cord from the amp to the first speaker and then run a 1/4" cord from...
Answer:
You would better off running a separate wire to each speaker. A bridged connection is when you use position...
MMike at Yahoo! Answers Mark as irrelevant Undo
so my dad has a 4 runner and currently it has some no name rockwood 500 watt 2 channel amp in the trunk. its pushing 2 20 year old pyle 12" subs and 2 pioneer 5 way 6x9 80 watt rms speakers. i was wondering which 2 channel kicker zx amp would be...
Answer:
ok, so you want to power the front and rear speakers i take it? but if this is the case. then why not...
lilscorp... at Yahoo! Answers Mark as irrelevant Undo
I have a 3500 watt class D mono block amp and 1500 watt subs. I need a amp install kit that will bring out the full potential and I want the best deal on it. Best buy or any local car audio store I called where completely incompetent. For example one...
Answer:
You need to decide on one or the other. Either name your minimum specs or the most you're willing to...
Currency... at Yahoo! Answers Mark as irrelevant Undo
I have 2 10" subs at 300rms that are dvc and 4 ohms. So I should get a 600w rms amp, right? now, what is the best way to wire the subs, or are they all the same, just mixing it up? what does bridging do? should i get a mono amp, 2 ch amp, or 4 ch...
Answer:
Yes, a 600 watt RMS amp would be great. You can go a little over or under and still be OK. Probably...
constant... at Yahoo! Answers Mark as irrelevant Undo
Related Q & A:
- What is the best amp for a 12" Alpine Type R?Best solution by Yahoo! Answers
- I have the memphis 12 pr's and what will be the best amp for them.Best solution by Yahoo! Answers
- What would be the best amp for this sub?Best solution by Yahoo! Answers
- What is the best amp for 2 kenwoods KFCW3012?Best solution by Yahoo! Answers
- What would the best amp for a 1222d type R sub?Best solution by carreview.com
Just Added Q & A:
- How many active mobile subscribers are there in China?Best solution by Quora
- How to find the right vacation?Best solution by bookit.com
- How To Make Your Own Primer?Best solution by thekrazycouponlady.com
- How do you get the domain & range?Best solution by ChaCha
- How do you open pop up blockers?Best solution by Yahoo! Answers
For every problem there is a solution! Proved by Solucija.
-
Got an issue and looking for advice?
-
Ask Solucija to search every corner of the Web for help.
-
Get workable solutions and helpful tips in a moment.
Just ask Solucija about an issue you face and immediately get a list of ready solutions, answers and tips from other Internet users. We always provide the most suitable and complete answer to your question at the top, along with a few good alternatives below.