What adapters are needed to plug plain speaker wire into a computer's speaker output?
-
Hello. Before I begin I feel the need to remind everyone that this is my setup and I am not planning on changing it, even if you give me suggestions on how to get a better system. I recently purchased two in-ceiling speakers and two 50ft lengths of speaker cable to use with them (I already mounted the speakers and have the wires routed how I want them.) However, I want them all plugged in to the same computer and all running mono. The computer has the green, blue, and red ports on the back, which I presume to be speakers, line input, and microphone (not important.) How do I take two sets of right/left speaker wire (just the bare wire right now, not even any banana plugs yet) and have them all connected to the computer so that they all receive equal sound output? Please be detailed, as I am new to audio systems (I usually just use the built-in speakers as programming is my fancy.)
-
Answer:
No such adaptor exist. Well, it does but it's called an amplifier. Speakers are composed of a coil in a magnetic field... a linear motor. Key word is motor, it requires power. The output on your sound card is not designed to drive a speaker directly. Basically you are asking for an adaptor to connect the gas pedal in your car directly to the wheels so you don't need an engine. It simply doesn't work that way. You could try something like this... http://www.parts-express.com/pe/showdetl.cfm?Partnumber=300-383 mk
dangerca... at Yahoo! Answers Visit the source
Other answers
You need a receiver to power the speakers, and to route the desired signals to where you want. Computers do NOT have any audio amplifiers with which to drive speakers, which is why small desktop computer speakers have a tiny amp built into one of them. But, to run speakers such as what you describe, such a tiny and weak amp won't come close to doing it. So, buy a receiver, run the speaker wires to it's speaker outputs, and use a cable with a 3.5 stereo male plug on one end and twin RCA male jacks at the other. Put the 3.5 plug in the speaker out of the computer, and the twin RCA jacks into an audio in on the receiver. That's how my desktop is plugged into the home theater audio setup I have in my office. A good basic receiver would cost about $200, like a Pioneer 521K at Amaz*n.
ANDRE L
Related Q & A:
- What kind of job will I have to do as a computer engineer?Best solution by Yahoo! Answers
- What is the difference between a Computer science (A.S.) and Computer Information Systems (A.S?Best solution by Yahoo! Answers
- What gauge for speaker wire??Best solution by Home Improvement
- What is the best 32" lcd tv to use as a computer monitor?Best solution by Yahoo! Answers
- What size speaker wire do I need?Best solution by eHow old
Just Added Q & A:
- How many active mobile subscribers are there in China?Best solution by Quora
- How to find the right vacation?Best solution by bookit.com
- How To Make Your Own Primer?Best solution by thekrazycouponlady.com
- How do you get the domain & range?Best solution by ChaCha
- How do you open pop up blockers?Best solution by Yahoo! Answers
For every problem there is a solution! Proved by Solucija.
-
Got an issue and looking for advice?
-
Ask Solucija to search every corner of the Web for help.
-
Get workable solutions and helpful tips in a moment.
Just ask Solucija about an issue you face and immediately get a list of ready solutions, answers and tips from other Internet users. We always provide the most suitable and complete answer to your question at the top, along with a few good alternatives below.