What is the correct torque for 2002 q 45 valve cover gaskets bolts?
-
i need to torque down my bolts for the valve cover gaskets, what is the correct amount of torque do i need in pounds i think 20pound of torque should be enough, does anybody have any info on this thanks?
-
Answer:
1st step: 1.0 - 3.0 Nm (0.1 - 0.31 kg-m, 9 - 26 inch lbs.) 2nd step: 7.4 - 9.3 Nm (0.75 - 0.95 kg-m, 66 - 82 inch lbs.) You need to use gasket sealant at 4 locations for a proper seal.
angelo37... at Yahoo! Answers Visit the source
Other answers
Too much.
Dennis
Related Q & A:
- What is the correct way to do pin curls?Best solution by Yahoo! Answers
- Where can I get Valve Cover Bolts for My 94 Civic Vtech?Best solution by Yahoo! Answers
- What is the correct setting for my outgoing SSL?Best solution by mail2web.com
- What is the Bolt Pattern for 2002 Ford Explorer Sport?Best solution by Yahoo! Answers
- What is the correct way to do the robot?Best solution by Yahoo! Answers
Just Added Q & A:
- How many active mobile subscribers are there in China?Best solution by Quora
- How to find the right vacation?Best solution by bookit.com
- How To Make Your Own Primer?Best solution by thekrazycouponlady.com
- How do you get the domain & range?Best solution by ChaCha
- How do you open pop up blockers?Best solution by Yahoo! Answers
For every problem there is a solution! Proved by Solucija.
-
Got an issue and looking for advice?
-
Ask Solucija to search every corner of the Web for help.
-
Get workable solutions and helpful tips in a moment.
Just ask Solucija about an issue you face and immediately get a list of ready solutions, answers and tips from other Internet users. We always provide the most suitable and complete answer to your question at the top, along with a few good alternatives below.