How do I bridge two different amps together?

Is it possible to bridge two amps together for more power?

• I have two 1800 watt kenwoods, but both of them blew. I now downgraded my system with a kenwood kac 7202 2 channel amp. I found this in the manual and was wondering if it would work with a 2 2 channel amps? Dual Mono Drive (Function of the KAC-9152D) 1. Connect the 9 speaker wire to the 9 terminal of amplifier ¡. Also, connect the · speaker wire to the 9 terminal of amplifier ™. 2. Connect between · terminals of amplifiers ¡ and ™. 3. The remote controller can be used just when connected to amplifier ¡. It can be used for more fine control if also connected to amplifier ™. 2CAUTION • Always connect between · terminals of amplifiers ¡ and ™. If a cable is incorrectly connected between 9 and · terminals of these amplifiers, the amplifier protection circuit is turned on. • Use a speaker having the 2Ω or higher impedance only. • To protect the electrical system from a short-circuiting, be sure to remove the · battery cable from the vehicle in advance. • Fully insulate amplifier terminals and speaker terminals to avoid a high voltage from peripherals.

• Answer:

  An amp has to be intended for external bridging. I would be seriously surprised if you did this and one or both amps didn't fail. What you CAN do if you really want to drive a single sub with these two amps is just use a dvc 4 and have each amp drive its own voice coil