How to wire a 2001 Kawasaki klr250 with no wiring harness, to find out if it runs?
-
The motorcycle was stollen, then recovered stripped of parts & wiring harness.
-
Answer:
If coils, ignition, etc is there, use jumper cables and a battery, ground to the frame and the negative battery terminal, (or ground side of coil), and jumper positive battery terminal to positive side of coil.
GIL N at Yahoo! Answers Visit the source
Other answers
You need an ignition coil,CDI unit and pickup down at the crankshaft.
gdwrnch40
Related Q & A:
- How to Wire a telephone jack?Best solution by wikihow.com
- How do I remove the old stereo in a 2001 Chevy cavalier to install a new stereo?Best solution by Yahoo! Answers
- How to wire one 4ohm dvc sub to a monoblock amp so that its a 4 ohm load?Best solution by Yahoo! Answers
- How do you change the plugs on a 2001 Pontiac Montana?Best solution by answers.com
- How to wire a new stereo into a 1995 dodge intrepid?Best solution by Yahoo! Answers
Just Added Q & A:
- How many active mobile subscribers are there in China?Best solution by Quora
- How to find the right vacation?Best solution by bookit.com
- How To Make Your Own Primer?Best solution by thekrazycouponlady.com
- How do you get the domain & range?Best solution by ChaCha
- How do you open pop up blockers?Best solution by Yahoo! Answers
For every problem there is a solution! Proved by Solucija.
-
Got an issue and looking for advice?
-
Ask Solucija to search every corner of the Web for help.
-
Get workable solutions and helpful tips in a moment.
Just ask Solucija about an issue you face and immediately get a list of ready solutions, answers and tips from other Internet users. We always provide the most suitable and complete answer to your question at the top, along with a few good alternatives below.