What are some of New Zealand's prehistoric artifacts?

Why do I get visual artifacts when using ATI Radeon X300?

  • My brother got me this graphics card and everything was going fine until I changed the settings on C&C Red Alert 3. The screen went completely black apart from the cursor and many artifacts appeared on the screen. I could not return to the desktop so I had to turn the computer off by holding the power button. When I got the computer back on there were artifacts all over the screen and the monitor would suddenly stop detecting that it was plugged in to the card. I can only run the computer in safe mode but I still get the artifacts in safe mode. Any solutions?

  • Answer:

    No solution but a suggestion The ATI Radeon X300 came out about 8 years ago. C&C Red Alert 3 requires a minimum graphics card a lot better than that. Buy a new one.

Ryan D. C. at Yahoo! Answers Visit the source

Was this solution helpful to you?

Just Added Q & A:

Find solution

For every problem there is a solution! Proved by Solucija.

  • Got an issue and looking for advice?

  • Ask Solucija to search every corner of the Web for help.

  • Get workable solutions and helpful tips in a moment.

Just ask Solucija about an issue you face and immediately get a list of ready solutions, answers and tips from other Internet users. We always provide the most suitable and complete answer to your question at the top, along with a few good alternatives below.