How to remove ink from a cartridge?

How to REMOVE an ink cartridge?

  • THIS CARTRIDGE IS NOT EMPTY- when I press the maintenence button the cartridge carrier slides the cartridges out but does not stop like it does when a cartridge needs to be replaced- it goes directly into a nozzle clean action. How can I get it to stop so I can remove the cartridge? It's an EPSON Stylus printer.

  • Answer:

    so you want to replace the cartridge though it is not empty.you have to press the red switch until the carriage comes out to the replacement position.mind if you release the switch before that it will clean again and again and it will be easier to replace becouse the ink will be finished.first the bl cartridge will come then after replacing the bl press the sw again,the col will come after replacing it finally push the sw once more.the carriage will go inside and it will be installed.

papumsis at Yahoo! Answers Visit the source

Was this solution helpful to you?

Other answers

Been awhile since I had an Epson, but used to be open the lid and wait. It will come to the removal position without pushing any buttons.

Laid back

Just Added Q & A:

Find solution

For every problem there is a solution! Proved by Solucija.

  • Got an issue and looking for advice?

  • Ask Solucija to search every corner of the Web for help.

  • Get workable solutions and helpful tips in a moment.

Just ask Solucija about an issue you face and immediately get a list of ready solutions, answers and tips from other Internet users. We always provide the most suitable and complete answer to your question at the top, along with a few good alternatives below.