Why does my laptop keep freezing since I smashed the monitor?

Can't figure out why my new monitor will not get a signal from my laptop.?

  • I have a ViewSonic widescreen monitor and a great Intel Centrino 2.8Ghz with 1Gb Ram and plenty of hard drive space on my laptop. Once I connect everything and install the drivers, I press the Function and F8 key to try and switch from my laptop to the monitor but it isn't working. The monitor says No Signal even though everything is connected. What am I doing wrong?

  • Answer:

    hi, run the software again check for loose connections read the manual configure settings onbig screen (if available) configure the graphix card setting goto desktop>right clcik properties> settings advanced >configureit! last option! call customer care and blow their heads offfff AnswerMan

achristi... at Yahoo! Answers Visit the source

Was this solution helpful to you?

Other answers

fire wire, router not big enough, go through the steps again to check if all your plug and plays are installed

BlackWidow

You need to set the correct resolution for the monitor to work.

johndeereman

Make sure you turn you laptop screen off (Shut the lid)

fmtjatt

Find solution

For every problem there is a solution! Proved by Solucija.

  • Got an issue and looking for advice?

  • Ask Solucija to search every corner of the Web for help.

  • Get workable solutions and helpful tips in a moment.

Just ask Solucija about an issue you face and immediately get a list of ready solutions, answers and tips from other Internet users. We always provide the most suitable and complete answer to your question at the top, along with a few good alternatives below.