Find solution
What is wrong with my plasma screen?

What am I doing wrong connecting laptop to my 42" plasma screen?

  • After connecting my laptop to my 42" plasma screen I can only get it to work in safemode otherwise just the laptop screen shows up

  • Answer:

    If you do not get your answer here Try posting or searching at this site. They are the only people I use for computer Problems/Questions. And they are FREE. http://www.techsupportforum.com/

remmora2... at Yahoo! Answers Visit the source

Was this solution helpful to you?

Other answers

Try changing the properties of your graphic card to clone mode. Right click on desktop and goto Properties > Settings > Advanced Find the tab that corresponds to your graphic card special properties and set the display mode to Clone so that both the external source and your laptop's flat panel show the same content. Good luck

Behrooz

OK try pretending that you are connecting a laptop to the TV. In this similar scenario, the laptop is treating your plasma screen as a TV. You need to left click on your desktop wallpaper and select Properties. Go to Settings and Advances. Search for Monitor or something similar that show a picture of two monitor. Then, set the Monitor B as Primary or I would set it equal to Monitor A. That way the laptop screen will be showing as your plasma screen. Hope that help!!

bigmo19901

Related Q & A:

Just Added Q & A:

Find solution

For every problem there is a solution! Proved by Solucija.

  • Got an issue and looking for advice?

  • Ask Solucija to search every corner of the Web for help.

  • Get workable solutions and helpful tips in a moment.

Just ask Solucija about an issue you face and immediately get a list of ready solutions, answers and tips from other Internet users. We always provide the most suitable and complete answer to your question at the top, along with a few good alternatives below.