Find solution
Do you have to connect aerial to built in freeview tv?

Just purchased a JVC hdi Tv and cant connect my outside RTE Aerial?

  • I have connected TV, built in freeview is working perfectly. I have an RTE aerial on my roof the connection comes through the wall and its then connected to a booster box, the lead of the booster box is then connected into the back of then tv using the aerial socket. I cant seem 2 get any annalog tv stations a "No signal" warning appears when i choose to switch to annalog. It driving me insane, hopefully some1 from northern ireland or thereabouts will help me. I dont have any other boxes ie. sky or ntl so cannot connect aerial through them.

  • Answer:

    it may be a similar problem as when channel 5 had to send people to homes to re tune videos and TVs , i think that your new TV might start its search for the analogue signals at a frequency higher than your Ariel is receiving , on older videos for example there was a tiny adjust screw on the back to increase /decrease the range of channels that it searched for , as your TV is new it may be best to find the teck spec and then ask an Ariel guy for relevant booster.

d.connol... at Yahoo! Answers Visit the source

Was this solution helpful to you?

Related Q & A:

Just Added Q & A:

Find solution

For every problem there is a solution! Proved by Solucija.

  • Got an issue and looking for advice?

  • Ask Solucija to search every corner of the Web for help.

  • Get workable solutions and helpful tips in a moment.

Just ask Solucija about an issue you face and immediately get a list of ready solutions, answers and tips from other Internet users. We always provide the most suitable and complete answer to your question at the top, along with a few good alternatives below.