How can I get a better reception from my TV antenna?
-
I have tried everything I know of to get the antenna to work better. Any suggestions? (please don't say that I should get cable or satellite)
-
Answer:
You didn't' specify rooftop or basic TV top. If you are really serious you can try a antenna rotor. Turning your antenna will point it in the direction of the TX. signal. AS stated before check or replace your antenna connections. Next is this an old or new antenna? If you have in TV top antenna, you can a amplified antenna (this is only good if you get good signals). Radio Shack carries a variety of amplified antennas. You might want to make sure that your TV doesn't have a weak tuner.
thenamei... at Yahoo! Answers Visit the source
Other answers
put ur foot though it
black65day
try playing around wit hit or put foil on it
jerzhedevil
One of my teachers in high school told me that a copper wire wrapped around a strong magnet makes a pretty good antenna. Make sure that you use unshielded copper wire. You can find a strong magnet in a sub-woofer (not a new one, use a blown one). Then hook up one wire to each antenna node, or get a piece from radio shack that converts co-axel cable to the old-school style with the 2 screws. Don't do anything stupid like stick it in a power source.
Dan_o_mite
if you have old speacker wire 6 -7 foot at least fou feet atatch tie two ends to the u shaped terminals of your antinna and run it out side of a window closests to your set then attach the antinie to the tv
thelizzardking33
I am not sure what kind of antenna you are using but try putting it up higher in the air the higher it is the better the reception will be.. Good Luck I gave you a link below I hope it helps..
s_haggard00
mayb you should try getting some cable buddy
sexygurlie17
s_haggard00 gave good advice and that link should be useful to you too. Also, check the antenna carefully for any corrosion between the various parts. If there is any clean it off - you may have to disassemble it to do this. Pay attention to the connections between the feeder wire and the antenna, make sure they're good. Spraying with a silicon solution, both at the metal joints and the connections, will slow down corrosion in the future. If the feeder is coaxial cable and it has been installed for a long time it may have deteriorated, especially from the ingress of water from the antenna end and through porosity in the outer sheath due to U.V. from the sun, and it might be worth replacing it.
dmb06851
add foil?
skatey25
Related Q & A:
- How can I get a better sleeping pattern?Best solution by Yahoo! Answers
- How can I find a better job while I am currently working?
- How can I be a better boyfriend?Best solution by Yahoo! Answers
- How can i get a better singing voice?Best solution by Yahoo! Answers
- Can I get a better signal than 480i?Best solution by Yahoo! Answers
Just Added Q & A:
- How many active mobile subscribers are there in China?Best solution by Quora
- How to find the right vacation?Best solution by bookit.com
- How To Make Your Own Primer?Best solution by thekrazycouponlady.com
- How do you get the domain & range?Best solution by ChaCha
- How do you open pop up blockers?Best solution by Yahoo! Answers
For every problem there is a solution! Proved by Solucija.
-
Got an issue and looking for advice?
-
Ask Solucija to search every corner of the Web for help.
-
Get workable solutions and helpful tips in a moment.
Just ask Solucija about an issue you face and immediately get a list of ready solutions, answers and tips from other Internet users. We always provide the most suitable and complete answer to your question at the top, along with a few good alternatives below.