Find solution
How do I install gauge cluster?

I just finished my NA - TT swap on my Z finally have the car running have a big issue with my gauge cluster wh?

  • i just finished my NA - TT swap on my Z finally have the car running have a big issue with my gauge cluster when i turn the car to the acc position the Temp gauge spikes to high and the rpm cluster spike to 3K and stay there even when i turn the car on it does the same exact thing tried using another cluster same thing tried another ecu does the same thing can some one please help me PS. i have swapped the dash out aswell dont know if that would cause the problem , somebody said it could be a bad ground but where the heck would the ground for the cluster be ? Please let me know if you need more details to help me solve the problem thank you .

  • Answer:

    I think there is a ground issue remember those two ground wires on back of the intake and the intake to plenium ground? also ground at the 8 mm bolt on the alternator as well as the bell housing ground.

Danielle F at Yahoo! Answers Visit the source

Was this solution helpful to you?

Other answers

Might want to make sure you swapped in a TT ECU (which you probably did, but doesn't hurt to make sure). Only think I can think of is that somewhere during the swap, a wire or sensor came loose from the engine.

The boosted one

Related Q & A:

Just Added Q & A:

Find solution

For every problem there is a solution! Proved by Solucija.

  • Got an issue and looking for advice?

  • Ask Solucija to search every corner of the Web for help.

  • Get workable solutions and helpful tips in a moment.

Just ask Solucija about an issue you face and immediately get a list of ready solutions, answers and tips from other Internet users. We always provide the most suitable and complete answer to your question at the top, along with a few good alternatives below.