Can I swap a 300zx tt into a 300zx 2+2?

Did a 300zx tt swap, driveshafts different lengths. any suggestions?

  • hi, i just did a 300zx tt swap. i bought a jdm motor and got a auto trans for it. well, i bought a tt driveshaft too for the fact that the old driveshaft dosent fit the transmission. the tt driveshaft i bought(stock) is shorter than the na one and also it has a different end bolt pattern. what do i do about this? i heard theres an adapter available, but i cannot find one. please help!!

  • Answer:

    Wow what a strange combination TT automatic? 300ZX TT use a CV joint in the rear. The common methiod is to use a NA single piece drive shaft (replacement) I just threw out a automatic rebuildable two piece drive shaft. It had sit under my bench for over 2 years. A couple questions? Coupe or 2+2 ?

Mohammad at Yahoo! Answers Visit the source

Was this solution helpful to you?

Just Added Q & A:

Find solution

For every problem there is a solution! Proved by Solucija.

  • Got an issue and looking for advice?

  • Ask Solucija to search every corner of the Web for help.

  • Get workable solutions and helpful tips in a moment.

Just ask Solucija about an issue you face and immediately get a list of ready solutions, answers and tips from other Internet users. We always provide the most suitable and complete answer to your question at the top, along with a few good alternatives below.