Find solution
Why the autorelease pool is necessary in main.m?

Installing a 24ft round above ground pool,Why is liner tight on pool wall?

  • We have done all the steps prior to liner installation (leveled the ground,5 tons of sand on the floor,pavers, wall up,etc...) Now we are installing the liner included with the pool kit. We lined the floor to the pool wall and pulled the liner over the wall. But the liner is tight on the wall on one side. Causing a gap between the liner and wall. How can we correct this ? We have tried moving the liner around. Is their something else we should check? It is a round 24ft pool. I`m concerned the liner will tear with the weight of the water. Any help or suggestions would be appreciated.

  • Answer:

    I installed an 18 ft round pool 2 yrs ago and had the same problem. We just put the top rail on and filled it with water. I have not had any problems with it it might just need to be stretched a little. I wouldn't worry too much about it.

pool help at Yahoo! Answers Visit the source

Was this solution helpful to you?

Other answers

Humm wonder if they gave you the right size liner? When we put our new liner in last year we let it lay in the sun for awhile to soften it up and we didn't have any problems, you don't have the liner slightly twisted do you? If you can't reslove the problem call the place where you purchased the pool and see if they have any suggestions.

judy_derr38565

Related Q & A:

Just Added Q & A:

Find solution

For every problem there is a solution! Proved by Solucija.

  • Got an issue and looking for advice?

  • Ask Solucija to search every corner of the Web for help.

  • Get workable solutions and helpful tips in a moment.

Just ask Solucija about an issue you face and immediately get a list of ready solutions, answers and tips from other Internet users. We always provide the most suitable and complete answer to your question at the top, along with a few good alternatives below.