Find solution
Where to get trainings to be a renovation contractor?

How do I get rid of mold in the bathroom ceiling for good?I have an infant so I'm afraid to bathe her in there

  • We are undergoing a major renovation at our home. Our contractor had put the walls up but not a roof yet. We had very heavy rainfall that night and water was streaming down our kitchen, laundry, and bathroom walls. Nevertheless, we are dealing with mold now because of the water damage. Our contractor said he cannot do anything about it until we get to the drywall stage which could be another few weeks because of all the inspections required before we get to that point. I'm really scared to even go in the bathroom for fear my 9 month old daughter will get sick. Our contractor admitted it was his fault and that he will fix it. He wants to put bleach on it and KILZ? over it. I don't think that is going to fix the mold problem. What is the BEST way to get rid of the mold problem for good? Thank you.

  • Answer:

    KILZ-binning the area is a good temporary idea. it will cover and seal the mold for good. This is what emergency comapnies use for water and fire damage immediately. Your contractor should not have let the roof go undone. He should seal all the nailers with bin at his own expense. Inspections should NOT take that long. As a concerned homeowner call up and harass them to get an appointment sooner. They will pay more attention to you than the contractor. Also in certain areas, drywal CAN go up before inspections are done AS LONG AS ONLY ONE SIDE OF THE WALL IS ROCKED TO LEAVE IT VISIBLE FOR INSPECTION.

sarazein... at Yahoo! Answers Visit the source

Was this solution helpful to you?

Other answers

Actually my grandfather told me that bleach is the #1 killer of mold. It'll work. Whether it will work on the drywall, I'm not sure. The best thing your contractor could do for you though is probably redo the walls themselves. But for now, bleach should make it safe enough.

earthsparkle_88

Bleach and water in a pump up garden sprayer. After drywall is up install a really good vent fan. These can be $$$, so expect to pay $80-120 for a good one. Good luck

urmyfavorite

In a way it's a good thing you're not at the drywall stage because if you were, it would have to be redone. Yes, bleach will kill the fungus and kilz will seal it in to where it cannot regrow. Unless your baby has breathing problems to begin with, he is not likely to be any more susceptible to problems from mold than an adult. In fact, babies' immune systems are at a point when they are sensing antigens in the environment, rather than reacting to them allergically. A adult who spent their childhood in a mold-free environment until the age of 12 is more likely to have a problem.

dinotheorist

The bleach will do the job, until he can fix it properly.

pebbles

cover it in miracle whip it should all be good but dont touch it it will grow on your arm and not the mold im talking about dot dot dot

grand master killa

Going by your question, the drywall is not installed? If not I do not know how mold would develop so quickly unless it was present in the framing already. Either way. If the mold is on the framing timber a total good soaking of bleach will work (make sure it is allowed to dry 100% before covering. However if the DW is up then the bleach is unlikely to do the job as the mold is probably all the way through the DW. If this is the contractors fault remember that you are paying for a professional installation free of any concerns on completion - if it costs him money or profit he should have been professional enough to protect the area from rain. The Drywall and any vapour barrier should be removed and the framing treated with bleach. Have a good quality ventilation fan installed rated slightly higher than required for the volume of the room (to large might be too noisy) and make sure it is vented to the exterior of the house which frequently is done via soffit vents or end gables - not just into the attic space as this may cause mold or moisture related probs later. Vapour barrier should be UV rated heavy plastic on all exterior walls (ceiling to attic is exterior) and sealed properly. Your concerns should apply to any area that was soaked by water. Mold is not something to mess around with - especially for children and seniors. If you are paying market price for the renovation everything should be done leaving you with zero concerns and feeling satisfied with the work done - anything less is not acceptable. As a guide, the minimum hourly rate for any serious renovation contractor in Canada should be $50 hr plus. In the USA I would imagine this would be around $40. Anything less and good luck finding him later for any repairs - chances are he/she will be out of business.

GreenDude

The best way to kill mold is to make a mixture of miracle whip, mustard, milk, hot sauce and (it sounds disgusting but it works) urine. The acids in all the ingredients will kill off any kind of mold.

Joe

The first thing you need is a roof that will shed the water. Then you can start to deal with the mold issue. It may behove you to have some testing done before this process is finished. DO NOT BLEACH. Contrary to popular belief, bleach will not kill the mold. You need to clean and thoroughly dry ALL materials before encapsulating (painting or drywalling). Visit www. horizon-inspections.com, mold page for more info regarding mold issues. Please feel free to email me with additional details if you wish.

tim r

yes put bleach on it . then ventolate the room well . after this other work is done and before you pay one cent have the dry wall taken down look on the back side for mold as well . they may find lots or they may find little and say they dont want to rip all the dry wall down . if they say that then ask for random holes to be cut in the walls check them yourself and have any that are black removed. you are right mold is deadly . not just to children but to everyone

sandy l

Load more

Related Q & A:

Just Added Q & A:

Find solution

For every problem there is a solution! Proved by Solucija.

  • Got an issue and looking for advice?

  • Ask Solucija to search every corner of the Web for help.

  • Get workable solutions and helpful tips in a moment.

Just ask Solucija about an issue you face and immediately get a list of ready solutions, answers and tips from other Internet users. We always provide the most suitable and complete answer to your question at the top, along with a few good alternatives below.