Is there a better way to attach a tin elbow/hose to a dryer outlet than a metal/plastic clamp or duct tape?
-
The dryer outlet is only ~1/2" long and inadequate to get a snug fit between a 4" tin elbow/hose when using a clamp. The clamp isn't designed to tighten at any angle in relation to the pipe, and any extension easily falls off. Duct tape doesn't work either as this gets damp and loses its sticking properties. I've tried a plastic extension in the past, but found the adhesive ring to have the same problem, because the extension can only "hang on" with the 1/2" available on the dryer outlet. I'd rather not resort to superglue... please help.
-
Answer:
don't know
Joe W at Yahoo! Answers Visit the source
Other answers
Sucks, huh? I understand that they want to minimize the space at the back, but it makes it hard to get a positive seal. I just installed a new dryer yesterday and found the only way to do it properly was to remove the service cover from the rear of the dryer, pull the piece of duct off the blower, tape and clamp the elbow, and re-install the duct into the dryer. On my model (Frigidaire), the internal duct is only sealed with a little rubber gasket, but it is screwed into the back of the unit, so it won't move. Good luck!
mekkichi
had this prob in the past get some 1/4 inch self tapping screws and 1/4 washers and use a cordless drill to screw the flex hose into the outlet about three screws should do it they will easily go through flex hose and into dryer vent tube and should hold tightly good luck as not alot of room so screws should go in at angle...
lost_sole_28
DO NOT USE SCREWS. Lint will catch on the screws, plug up your vent, interfere with clothes drying, and be a fire hazard. Use the clamps.
budde ugly
Related Q & A:
- Is there a way to attach a picture to your question?Best solution by Yahoo! Answers
- What would be a creative way to make a timeline?Best solution by Yahoo! Answers
- What's a good way to let a girl know you are interested in her?Best solution by Yahoo! Answers
- To those who know how to hide a solder joint in a metal ring?Best solution by Yahoo! Answers
- What is the better way to get a part time job?Best solution by ChaCha
Just Added Q & A:
- How many active mobile subscribers are there in China?Best solution by Quora
- How to find the right vacation?Best solution by bookit.com
- How To Make Your Own Primer?Best solution by thekrazycouponlady.com
- How do you get the domain & range?Best solution by ChaCha
- How do you open pop up blockers?Best solution by Yahoo! Answers
For every problem there is a solution! Proved by Solucija.
-
Got an issue and looking for advice?
-
Ask Solucija to search every corner of the Web for help.
-
Get workable solutions and helpful tips in a moment.
Just ask Solucija about an issue you face and immediately get a list of ready solutions, answers and tips from other Internet users. We always provide the most suitable and complete answer to your question at the top, along with a few good alternatives below.