How to fix 3 red rings of death on the xbox 360?

How to Fix the 3 Rings of Death on an Xbox 360

  • Answer:

    Since the Xbox 360 was introduced, users have been plagued with the infamous "Red Ring of Death," denoted by three flashing red lights on the system's Ring of Light. More often than not, this indicates a hardware failure. The cause of this problem is probably is the system has overheated. It can be remedied by reapplying thermal compound to the CPU and GPU. Difficulty: Moderate Things You'll Need T6, T7 and T12 Torx screwdriver XCM 360 case opening tool ArctiClean 1 and 2 Arctic Silver 5 thermal compound Instructions Disassemble the Xbox 360 Unplug all power cables, video cables, controllers, hard drive and anything else that is plugged into the Xbox 360. Remove the faceplate by inserting your fingers into the USB port and pulling off the faceplate. Remove the gray side plates on each side. Insert the case opening tool into the holes on the top and bottom of the console to unhinge the gray plate connectors. There are eight connectors in all. Flip the Xbox upside-down and lift open the lid just a little using the case opening tool. Locate the seven rectangular holes between the top shell and the bottom shell. Insert the case opening tool into the holes. You will hear a crisp click as the latches are unlocked. Undo the four latches on the front of the console. The two halves should separate, revealing the inside of the console. Remove the Motherboard Unscrew the 14 silver screws with the T12 Torx screwdriver and the eight black screws with the T7 Torx screwdriver. Flip the Xbox right-side up, and the top shell will slide off. Remove the DVD drive. Unplug the DVD power supply and Serial ATA interface and lift it out of the Xbox. Remove the fan. Lift of the white air guide, unplug the fan and gently pry the fan from its fastening clips. Unscrew the RF unit using a T6 Torx screwdriver. Remove the cover and unscrew one last screw. Pull the RF unit out of the console. Life the motherboard out of the console, unplugging anything that might still be connected. Apply Thermal Compound Remove the X-clamp on the bottom of the motherboard by gently prying it off. Unscrew the heatsink on the top of the motherboard to reveal the CPU and GPU. Clean the CPU and GPU using ArctiClean 1 and 2. Apply Arctic Silver 5 thermal compound to the CPU and GPU and let it set for 15 minutes. Follow the steps in reverse order to reassemble the Xbox, and it should be cleared of the Red Ring of Death. Tips & Warnings Warning: Always use firm but gently motions when prying. Forcing anything open can cause damage. Warning: Opening your console will void your warranty, so if your console is still covered, it is best to send it in to Microsoft for repair. Warning: The only way to guarantee a Red Ring fix is to send in you Xbox for repair.

Monty McCormick at eHow old Visit the source

Was this solution helpful to you?

Related Q & A:

Just Added Q & A:

Find solution

For every problem there is a solution! Proved by Solucija.

  • Got an issue and looking for advice?

  • Ask Solucija to search every corner of the Web for help.

  • Get workable solutions and helpful tips in a moment.

Just ask Solucija about an issue you face and immediately get a list of ready solutions, answers and tips from other Internet users. We always provide the most suitable and complete answer to your question at the top, along with a few good alternatives below.