How would i wire 2 4ohm single voice coil subwoofers?
-
im looking at getting 2 Kenwood KFC-W3012 subwoofers and their 4ohm single voice coil. how would i wire them and what ohm load would i reach? if i get a class D monoblock amp would i get the 4ohm load or the 2ohm load or the 1 ohm load? thanks
-
Answer:
yeah like james said.. but why kenwood????lookin at those specs it says it only go down to 39.. missin the whole lower octave... and if the qts is right on the crutchfield site than it is for open baffle configs....
Eric at Yahoo! Answers Visit the source
Other answers
if your amp is 2 ohm stable it will put more power out at 2 ohms. wire both subs positive to positive and negitive to negitive and that will be a 2 ohm load.
Related Q & A:
- How do I wire 2 amps properly?Best solution by Yahoo! Answers
- How do I wire to Rockford subs?Best solution by Yahoo! Answers
- How do I wire this amp/sub up?Best solution by Yahoo! Answers
- How would I wire subs to AMP?Best solution by Yahoo! Answers
- How do I wire up two separate amps in my car?Best solution by Yahoo! Answers
Just Added Q & A:
- How many active mobile subscribers are there in China?Best solution by Quora
- How to find the right vacation?Best solution by bookit.com
- How To Make Your Own Primer?Best solution by thekrazycouponlady.com
- How do you get the domain & range?Best solution by ChaCha
- How do you open pop up blockers?Best solution by Yahoo! Answers
For every problem there is a solution! Proved by Solucija.
-
Got an issue and looking for advice?
-
Ask Solucija to search every corner of the Web for help.
-
Get workable solutions and helpful tips in a moment.
Just ask Solucija about an issue you face and immediately get a list of ready solutions, answers and tips from other Internet users. We always provide the most suitable and complete answer to your question at the top, along with a few good alternatives below.