How do i connect my dvd to my car power supply?

Car stereo won't power on?

  • My aftermarket in-dash car dvd stereo won't power on after I installed it to my car but it has a standby power. Then I tried connect it directly to the car's battery it works just fine. All fuses checked. What could be the other problem?

  • Answer:

    It sounds like you are not getting switched 12V+ to the red wire on the aftermarket unit. If you are using a wiring harness, check the appropriate pin with a voltmeter. If you wired the new unit directly to the factory wiring, check to make sure the red wire connects to your vehicle's switched 12+ wire and that the wire has power when the ignition is on.

laobunle... at Yahoo! Answers Visit the source

Was this solution helpful to you?

Other answers

could be your ground

Just Added Q & A:

Find solution

For every problem there is a solution! Proved by Solucija.

  • Got an issue and looking for advice?

  • Ask Solucija to search every corner of the Web for help.

  • Get workable solutions and helpful tips in a moment.

Just ask Solucija about an issue you face and immediately get a list of ready solutions, answers and tips from other Internet users. We always provide the most suitable and complete answer to your question at the top, along with a few good alternatives below.