What is a good amp to power up a 15" kicker cvr?

PLEASE HELP!!! can a hifonics amp power my these four kicker subs?

• WILL A HIFONICS BXI 2010D MONO AMP BE ENOUGH TO POWER 2 KICKER L7 4 OHM 10's AND 2 KICKER CVR 4 OHM 15's? both of the L7 10's have a combined rms of 1200 watts.. and both of the CVR 15's have a combined rms of 1000 watts.. THATS A COMBINED TOTAL OF 2200 WATSS RMS. Suposably the Hifonics BXI 2010D could put out 2000 watts. I know that hifonics amps aint the best out there but i could get a pretty goOd deal on this amp. If my subs are wired the right way would this 2000 watt mono amp be enough to push all 4 subs of a combined rms of 2200 watts. AND IF SO WHAT WOULD BE THE BEST WAY FOR ME TO WIRE THE SUBS? also can can i damage the amp by conecting all 4 subs??? PLEASE HELP!!!!!!!

• Answer:

  That amp should do a fair job at powering those subs but your wiring is the issue. I assume that you already have the amp. If I were you, I would wire it in and see what you think. I am guessing that you will be satisfied but maybe not. You are going to need a SERIOUS amp wiring kit. I would go with 0 or at least 1 gauge power and ground wires. You might consider a circuit breaker over an in-line fuse if they keep popping. That amp is 1 ohm stable only. Those subs are dual voice coil so you could wire them in a way that you get below 1 ohm and damage your amp. Check out this link: http://www.the12volt.com/caraudio/woofer_configurations.asp?Q=4&I=42 Option 1 will kill your amp. Option 2 will get you 2 ohms but will not maximize the potential of your amp. If you do not already have an amp, get two amps and go with option 1 here: http://www.the12volt.com/caraudio/woofer_configurations.asp?Q=2&I=42