How do I wire two dvc 4ohm subs to a 2 ohm stable 2 channel amp?
-
I have a 2000 watt 2 ohm stable 2 channel logic amp. I am trying to wire two 4 ohm dvc kicker cvrs. Is this even possible because my amp is not mono? Please help. I've gone through many pairs, I wana get it down right this time. Thanks
-
Answer:
this should help you i had the same question but with 2ohm subs http://akamaipix.crutchfield.com/ca/learningcenter/car/subwoofer_wiring/2DVC_4-ohm_2ch.jpg
JJ at Yahoo! Answers Visit the source
Other answers
All you gotta do is wire the first channel to one sub in parallel and the second channel to the other sub in parallel. Since they are DVC4's, it will give you a 2 ohm total load per channel
RF_lover
Related Q & A:
- How do I wire 2 amps properly?Best solution by Yahoo! Answers
- How do I wire to Rockford subs?Best solution by Yahoo! Answers
- How do I wire this amp/sub up?Best solution by Yahoo! Answers
- How would I wire subs to AMP?Best solution by Yahoo! Answers
- How do I wire up two separate amps in my car?Best solution by Yahoo! Answers
Just Added Q & A:
- How many active mobile subscribers are there in China?Best solution by Quora
- How to find the right vacation?Best solution by bookit.com
- How To Make Your Own Primer?Best solution by thekrazycouponlady.com
- How do you get the domain & range?Best solution by ChaCha
- How do you open pop up blockers?Best solution by Yahoo! Answers
For every problem there is a solution! Proved by Solucija.
-
Got an issue and looking for advice?
-
Ask Solucija to search every corner of the Web for help.
-
Get workable solutions and helpful tips in a moment.
Just ask Solucija about an issue you face and immediately get a list of ready solutions, answers and tips from other Internet users. We always provide the most suitable and complete answer to your question at the top, along with a few good alternatives below.