Find solution
How to make a cheap helmet camera?

How to make this camera a helmet cam?

  • I GOT A LUMIX DIGITAL CAMERA THAT I WANT TO PUT ON MY HELMET TO FILM ME RIDE MY DIRT BIKE, IM 14 AND DONT GOT THE MONEY FOR A GO PRO AND THIS IS WHAT A GOT IF YOU COULD TELL ME SOME WAYS TO STICK IT ON THERE THAT WOULD BE GREAT. THANKS

  • Answer:

    WHY ARE YOU SHOUTING? JUST USE DUCK TAPE MAN!

Jeremy at Yahoo! Answers Visit the source

Was this solution helpful to you?

Other answers

You know on the bottom of camera where the tri pod screws into the camera? Well find a carriage bolt that screws into that. Then drill a hole on the top of you helmet and stick the carriage bolt through the hole so the threads are sticking out the top. Make sure the bolt isn't very long. Put a nut on the bolt so it tightens it down to the helmet. Then screw your camera on. Put some tape on the bolt on the inside and your good to go. You should beable to find a rubber plug at a hard ware store to put in the hole in the helmet when your not using the camera so it will look like its made like that.

In sixties and seventies, when cameras were MUCH heavier, they used lots of duct tape to attach them to helmets. Much of the famous movie "On Any Sunday" was shot this way. It's a lot easier now with today's very small and lightweight cameras. Do NOT drill any holes in your helmet: It will make the helmet MUCH weaker in a crash.

BUY A TRIPOD AND GLU IT TO UR CAMERA THT SHULD WORK YO WELCOMR

Related Q & A:

Just Added Q & A:

Find solution

For every problem there is a solution! Proved by Solucija.

  • Got an issue and looking for advice?

  • Ask Solucija to search every corner of the Web for help.

  • Get workable solutions and helpful tips in a moment.

Just ask Solucija about an issue you face and immediately get a list of ready solutions, answers and tips from other Internet users. We always provide the most suitable and complete answer to your question at the top, along with a few good alternatives below.