How to create another listview adapter?

Send and receive a multicast stream through virtual loopback adapter?

• Hello All, I've done some pretty serious searching over the last few days and can't find much on this topic, probably because it isn't possible, but perhaps the hive mind can guide me: Short story: I cannot see a multicast that is being sent out get "looped back" by the loopback adapter. I have a laptop with a Microsoft Virtual LoopBack Adapter installed and configured for: 172.16.70.70 - IP 255.255.255.255 - Subnet 172.16.70.70 - Gateway On this laptop I have a dev's software that is putting out a udp multicast video stream on 224.20.2.1:8208, which is captured by the demo software to simulate a live stream coming in from a live network. When connected to the general network everything works great and you can get to the multicast and view the stream. Yet when I try to capture the multicast with wireshark after enabling the loopback adapter (and disabling the physical NIC) I can see that the multicast simply isn't there. Is what I'm trying to do possible without a router to create the multicast group for the laptop to join? Is there something simple my Dev may need to change in his software to trick the network stack to loopback the multicast? I hope I've provided enough information. The only possible solution I can find is to install some sort of router emulation software (i.e. GNS3) but I'm delving even deeper over my head than I already am if that is the case. Thanks!

• Answer:

  There is nothing simple for your Dev to change in his software... Good luck!