Find solution
How do I set Hyper Cam 2?

How to set cam timing?

  • My 01 elantra has an p0430 (cam poistion sensor) code... i just changed the water pump which was behind the timing belt, i believe i installed the belt with my cam timing off. It is probably only off a tooth or so, because it runs. my question is how do i set time now?...............get the car in tdc and adjust as necessary?plz help

  • Answer:

    YOU should have manual or else you may bend the valve if your engine interference one

TrueOne at Yahoo! Answers Visit the source

Was this solution helpful to you?

Other answers

Its different with every car. New belts sometimes have marks on them that you line up with marks or arrows on the cam gears themselves. Some have marks on the timing case themselves that you line up. Check with your local dealership, they should be nice enough to help you out with some of that information. All Data should have the procedure

1 tdc. aling marks set tensioner rotate motor 2 full turns by hand , recheck marks line up perfect if not redue it

pull the belt cover off and line up the timing marks to where they should be and reinstall the belt. a book could be quite helpful in this. that code could mean that the cam sensor is not plugged in.

Related Q & A:

Just Added Q & A:

Find solution

For every problem there is a solution! Proved by Solucija.

  • Got an issue and looking for advice?

  • Ask Solucija to search every corner of the Web for help.

  • Get workable solutions and helpful tips in a moment.

Just ask Solucija about an issue you face and immediately get a list of ready solutions, answers and tips from other Internet users. We always provide the most suitable and complete answer to your question at the top, along with a few good alternatives below.