Can i make a mold?????????????
-
-
Answer:
There are two kinds of common molding rubber - the cheaper one is more time consuming and involves painting on multiple layers and letting each one dry/set - latex rubber - read more here http://www.mikegigi.com/modeling.htm#LATEXMOLD I have done foam with latex using spray fat as the separator which doesn't affect the foam as some others might. The other kind involves mixing two parts and pouring the result into a container around the object to be molded. The more common is silicone rubber but there are urethane molding compounds. I have not worked with them - there are video on the internet show it. If you were to mix up enough to dip, the remainder would also set, being very wasteful and costly. No product I am aware of will give you a useable mold by dipping into a coating and taking it out. There are rubber products out there that a dip coating - like for putting rubber on screwdriver handles or adding electrical insulation. But this rubber sticks tenaciously and does not stretch enough to get off an object without doing damage if the object is foam or other weak material like clay.
iAndrewgood at Yahoo! Answers Visit the source
Other answers
There are two kinds of common molding rubber - the cheaper one is more time consuming and involves painting on multiple layers and letting each one dry/set - latex rubber - read more here http://www.mikegigi.com/modeling.htm#LATEXMOLD I have done foam with latex using spray fat as the separator which doesn't affect the foam as some others might. The other kind involves mixing two parts and pouring the result into a container around the object to be molded. The more common is silicone rubber but there are urethane molding compounds. I have not worked with them - there are video on the internet show it. If you were to mix up enough to dip, the remainder would also set, being very wasteful and costly. No product I am aware of will give you a useable mold by dipping into a coating and taking it out. There are rubber products out there that a dip coating - like for putting rubber on screwdriver handles or adding electrical insulation. But this rubber sticks tenaciously and does not stretch enough to get off an object without doing damage if the object is foam or other weak material like clay.
Mike1942...
Related Q & A:
- How can I make a myspace comment into a picture caption?Best solution by Yahoo! Answers
- How can I make a hole through a stone or crystal?Best solution by Yahoo! Answers
- Can I make a PayPal account with a prepaid visa gift card?Best solution by Yahoo! Answers
- How can I make a mold at home?Best solution by eHow old
- How can I make a good resume even if I have no job experience?Best solution by Yahoo! Answers
Just Added Q & A:
- How many active mobile subscribers are there in China?Best solution by Quora
- How to find the right vacation?Best solution by bookit.com
- How To Make Your Own Primer?Best solution by thekrazycouponlady.com
- How do you get the domain & range?Best solution by ChaCha
- How do you open pop up blockers?Best solution by Yahoo! Answers
For every problem there is a solution! Proved by Solucija.
-
Got an issue and looking for advice?
-
Ask Solucija to search every corner of the Web for help.
-
Get workable solutions and helpful tips in a moment.
Just ask Solucija about an issue you face and immediately get a list of ready solutions, answers and tips from other Internet users. We always provide the most suitable and complete answer to your question at the top, along with a few good alternatives below.