Is Dolby pro logic 5.1 surround sound ?

Yes, but just barely. Dolby Surround/Pro Logic is based on basic matrix technology. When a Dolby Surround soundtrack is created, four channels of sound are matrix-encoded into an ordinary stereo (two channel) sound track. The centre channel is encoded by placing it equally in the left and right channels; the rear channel is encoded using phase shift techniques, typically an out of phase stereo mixdown. A Pro Logic decoder/processor "unfolds" the sound into the original 4.0 surround—left and right, center, and a single limited frequency-range (7 kHz low-pass filtered[1]) mono rear channel—while systems lacking the decoder play back the audio as standard stereo. A Pro-Logic decoder also uses 'Steering Logic', which drives amplifiers, to raise or lower the output volume of each channel based on the current dominant sound direction. For example, while a mono signal is played, the strong correlation to the center channel triggers the output volume of the left, right and surround channels to be lowered. This increases the channel separation achievable, to around 30 decibels between channels. By careful tuning of the response of the amplifiers, the total amount of signal energy remains constant and is unaffected by the operation of the channel steering. Additionally the response time of the system to changes in sound direction is important as too fast a response results in a twitchy feel, while too slow a response leaves sounds coming from an inappropriate direction.[2] In addition to 5db of noise processing, the surround channel is slightly delayed, so that any front channel sounds that leak into the surround channel arrive at the listener after the front channels, providing an illusion of greater separation. Although Dolby Surround was introduced as an analog format, all Dolby Digital decoders incorporate a digitally implemented Dolby Surround Pro Logic decoder for digital stereo signals that carry matrix-encoded Dolby Surround. One of the first was the MSP400 surround sound receiver and amplifier by RCA for their high-end Dimensia brand. It was released in 1987 for the Digital Command Component System.

Dolby pro logic is 4.0 surround there is no subwoofer channel and the rear speakers both receive the same signal....Dolby II is similar to pro-logic but it also includes a subwoofer channel and the rear 2 channels also get a separate signal one from the other....Dolby II has better quality sound, in dolby prologic the rear channel is also limited in output from 100hz to 15K hz where as Dolby II has 20 to 20K output capabilities....

Dolby pro logic is 4.0 surround there is no subwoofer channel and the rear speakers both receive the same signal....Dolby II is similar to pro-logic but it also includes a subwoofer channel and the rear 2 channels also get a separate signal one from the other....Dolby II has better quality sound, in dolby prologic the rear channel is also limited in output from 100hz to 15K hz where as Dolby II has 20 to 20K output capabilities....