Capture Card help?

Capture card help!!!?

• I bought an easycap capture card and when i try to install it, it said "An error occurred during the installation of the device". "The data is invalid". I tried to UN-install and RE-install it.I even installed the Ulead studio program first then the driver like it said in the manual but in the middle of installing the driver thats when the error occurred. it keeps saying this over and over again. please help!!!

• Answer:

  Important This section, method, or task contains steps that tell you how to modify the registry. However, serious problems might occur if you modify the registry incorrectly. Therefore, make sure that you follow these steps carefully. For added protection, back up the registry before you modify it. Then, you can restore the registry if a problem occurs. For more information about how to back up and restore the registry, click the following article number to view the article in the Microsoft Knowledge Base: 322756 How to back up and restore the registry in Windows Back to the top Method 1: Restore the default settings to the registry subkey for your device If you can determine which subkey is related to this issue, edit the registry to configure the correct settings on that subkey. For information about how to troubleshoot this issue and determine which subkey is affected by this issue, see the "More Information" section. To configure the correct settings on a specific subkey: Log on to the computer by using an account that has administrative credentials. Click Start, click Run, type regedit in the Open box, and then click OK. Locate the following registry key: HKEY_LOCAL_MACHINE\SYSTEM\CurrentContr... Right-click the subkey that is related to the device that is experiencing the symptom, and then click Permissions. Click Advanced, and then click the Permissions tab. Make sure that the following default permissions are configured: Everyone: Read System: Full Control Click to select the Replace permission entries on all child objects with entries shown here that apply to child objects check box, and then click Apply. Click Yes, and then click OK two times. Quit Registry Editor. If the issue is not resolved, repeat this procedure, and grant full control permissions to the Everyone group on this subkey. Back to the top Method 2: Restore the default permissions for the PCI key and for its subkeys Log on to the computer by using an account that has administrative credentials. Click Start, click Run, type regedit in the Open box, and then click OK. Locate the following registry key: HKEY_LOCAL_MACHINE\SYSTEM\CurrentContr... Right-click PCI, and then click Permissions. Make sure that the following default permissions are configured: Everyone: Read System: Full Control Click Advanced, click to select the Replace permission entries on all child objects with entries shown here that apply to child objects check box, and then click Apply. Click Yes, and then click OK two times. Quit Registry Editor.