How do you change a distributor cap and rotor?

How do you change a distributor cap and rotor on a 1993 thunderbird?

  • Answer:

    Distributor cap should have 2 clips - release these Rotor should just pull off - has a key to install in proper position make sure new is installed with key in slot Replace distributor cap -(should have a pin to insure it goes in only one position) Move one wire at a time from old to new so they don't get mixed up

community wiki at wiki.answers.com Visit the source

Was this solution helpful to you?

Just Added Q & A:

Find solution

For every problem there is a solution! Proved by Solucija.

  • Got an issue and looking for advice?

  • Ask Solucija to search every corner of the Web for help.

  • Get workable solutions and helpful tips in a moment.

Just ask Solucija about an issue you face and immediately get a list of ready solutions, answers and tips from other Internet users. We always provide the most suitable and complete answer to your question at the top, along with a few good alternatives below.