Where should we stay in Shenandoah National Park?

1999 Montana wipers wont park right I replaced the wiper motor. The wipers didnt park all the way down so i reset the wipers to park now they wont wipe the whole window they stay upright on int.?

• Answer:

  Answer: Copied from another site: You have a mechanical park switch which is part of the wiper crank arm.it acts as a clutch plate ,more than likely the mechinisim will have to be replaced .or Either the crank arm is bad, out of adjustment, or the crank arm tab is bent. Install the crank arm on the wiper motor. Turn the ignition switch to the ACCY position. Set the wiper switch to PULSE position. The wiper motor should be operating. Turn the ignition switch to OFF when the wiper motor is in the innerwipe position. Important Do not rotate the wiper motor shaft during the installation of the crank arm. Install the crank arm on the wiper motor while maintaining a 4-8 mm (0.157- 0.315 in) gap between the V-grove in the wiper motor crank arm and the tab. Install the screw. Tighten Tighten the screw to 14-17 N·m (124-150 lb in). Install the crank arm cover and seal. Check the gap between the crank arm and tab. If the gap is not 4-8 mm (0.157- 0.315 in), remove the crank arm and repeat installation steps. Install the drive link on the crank arm. Tighten the two drive link screws. Tighten Tighten the two screws to 5 N·m (44 lb in). Install the wiper system module cover. Operate the wipers and check for proper operation.