Find solution
How to program my dish remote?

How do you program a Dish Network remote to the receiver?

  • Answer:

    If you have one of our newer dual tuner receivers, there will be a sysinfo button on the front of the receiver, press it. If not, look through the menu screen till you find it. Once on that screen there is a section that tells you your remote addresses. All you have to do is press and hold SAT until the lights on top flash, type in 01, 02, etc. Then hit pound. the sat button should flash 3 times to let you know you entered a real command. Your remote should work after that.

Anonymous at ChaCha Visit the source

Was this solution helpful to you?

Other answers

If you have one of our newer dual tuner receivers, there will be a sysinfo button on the front of the receiver, press it. If not, look through the menu screen till you find it. Once on that screen there is a section that tells you your remote addresses. All you have to do is press and hold SAT until the lights on top flash, type in 01, 02, etc. Then hit pound. the sat button should flash 3 times to let you know you entered a real command. Your remote should work after that.

Related Q & A:

Just Added Q & A:

Find solution

For every problem there is a solution! Proved by Solucija.

  • Got an issue and looking for advice?

  • Ask Solucija to search every corner of the Web for help.

  • Get workable solutions and helpful tips in a moment.

Just ask Solucija about an issue you face and immediately get a list of ready solutions, answers and tips from other Internet users. We always provide the most suitable and complete answer to your question at the top, along with a few good alternatives below.