How to Wire a telephone jack?

How do you wire an RJ11 telephone jack?

  • Answer:

    To connect an RJ11 telephone jack, first, strip the telephone line providing the dial tone. Then, strip those wires to show the copper. Then, loosen the screws on the jack. Connect the red wire to the red screw, and tighten the screw. Connect the green wire to the green screw, and tighten the screw. Connect the black wire to the black screw, and tighten the screw. Connect the yellow wire to the yellow screw, and tighten the screw. If the wiring does not match the colors of the jack, then follow these steps: First, connect the blue wire to the red screw, and tighten the screw. Then, connect the blue/white wire to the green screw, and tighten the screw. Then, connect the orange/white wire to the black screw, and tighten the screw. Then, connect the orange wire to the yellow screw, and tighten the screw. Then, screw the jack onto the wall with the appropriate screws. Connect a working telephone to the jack, and check for a dial tone. If you hear a dial tone, then you have successfully connected all of the wires to the jack. If you do not hear a dial tone, check to make sure that all of the wires are securely on the screws, and that none of the copper has come off of the wire.

wiki.answers.com Visit the source

Was this solution helpful to you?

Related Q & A:

Just Added Q & A:

Find solution

For every problem there is a solution! Proved by Solucija.

  • Got an issue and looking for advice?

  • Ask Solucija to search every corner of the Web for help.

  • Get workable solutions and helpful tips in a moment.

Just ask Solucija about an issue you face and immediately get a list of ready solutions, answers and tips from other Internet users. We always provide the most suitable and complete answer to your question at the top, along with a few good alternatives below.