86 Pontiac 6000 stalls when put in drive or reverse?
-
-
Answer:
If the engine is running smoothly befor this, then read on... This is a very common problem. You have a faulty TCC solenoid. I have replaced this sensor with very simple tools (a 10 mm socket, a rachet, a gasket scraper, a T15 or T20 Torx driver, and replacement parts). It took me about 1 hour to complete having never done this job befor. The following link will tell you how to replace the sensor if you have a 125C tranny (3 speed). Althou the car pictured is a fiero, the same procedure applies. http://www.kichline.com/chuck/fiero/TCC.htm Good luck!!
wiki.answers.com Visit the source
Related Q & A:
- How do I put a custom PSP firmware when I have 3.71 firmware?Best solution by krizka.net
- When I get my permit in California, who can I drive around?Best solution by mycaliforniapermit.com
- What is a good thing to put on a job application when they ask whats the reason for leaving the position?Best solution by Yahoo! Answers
- How do you put free-on in a Pontiac Montana 2001?Best solution by answers.com
- When was the panda bear put on the endangered species list?Best solution by Yahoo! Answers
Just Added Q & A:
- How many active mobile subscribers are there in China?Best solution by Quora
- How to find the right vacation?Best solution by bookit.com
- How To Make Your Own Primer?Best solution by thekrazycouponlady.com
- How do you get the domain & range?Best solution by ChaCha
- How do you open pop up blockers?Best solution by Yahoo! Answers
For every problem there is a solution! Proved by Solucija.
-
Got an issue and looking for advice?
-
Ask Solucija to search every corner of the Web for help.
-
Get workable solutions and helpful tips in a moment.
Just ask Solucija about an issue you face and immediately get a list of ready solutions, answers and tips from other Internet users. We always provide the most suitable and complete answer to your question at the top, along with a few good alternatives below.