How do i wire (2) 1-3 ohm quad voice coil subs up to (2) ohms?
-
These are quad 1.3 ohm 5000 rms subs that im trying to wire to somewhere around 2 ohm and need help man,
-
Answer:
Wire them in series. Take the positive of one sub to the negative of the other and use the the others to connect to your amp. Mecp installer
JRY6QL5VRNGSGZCRHDW6WBT5LU at Yahoo! Answers Visit the source
Other answers
The above answer is almost correct. Wire the coils in series so that each sub is = to 5.2 ohms. then run the speakers in parallel going to the amp.this will make a 2.6 ohm load. It doesnt matter whether it is bridged or not, all the amp sees is what impedance you introduce it to. This is where the above answer is wrong. Cheers
Teh Finkster
Related Q & A:
- How do I wire 2 amps properly?Best solution by Yahoo! Answers
- How do I wire to Rockford subs?Best solution by Yahoo! Answers
- How do I wire this amp/sub up?Best solution by Yahoo! Answers
- How would I wire subs to AMP?Best solution by Yahoo! Answers
- How do I wire up two separate amps in my car?Best solution by Yahoo! Answers
Just Added Q & A:
- How many active mobile subscribers are there in China?Best solution by Quora
- How to find the right vacation?Best solution by bookit.com
- How To Make Your Own Primer?Best solution by thekrazycouponlady.com
- How do you get the domain & range?Best solution by ChaCha
- How do you open pop up blockers?Best solution by Yahoo! Answers
For every problem there is a solution! Proved by Solucija.
-
Got an issue and looking for advice?
-
Ask Solucija to search every corner of the Web for help.
-
Get workable solutions and helpful tips in a moment.
Just ask Solucija about an issue you face and immediately get a list of ready solutions, answers and tips from other Internet users. We always provide the most suitable and complete answer to your question at the top, along with a few good alternatives below.