Find solution
How do I replace the line on my Zebco spincast reel?

What are the steps to thread a new line in a Zebco 33 reel AFTER the line has been wound around the spool.?

  • I had removed the outer front cover and have unscewed the (?) theaded part from the shaft and found that a lot of line was wound up inside that unscrewed part (name unknown). I ...show more

  • Answer:

    change your line man

B2NVAFXTBNPHIX6LQSL7QKGDE4 at Yahoo! Answers Visit the source

Was this solution helpful to you?

Other answers

Not sure of problem but sounds as if you need to apply small amount of pressure to the line and reel it on because it is not being caught by the pickup. Never respool twisted line back into the reel it will cause trouble when it has been wrapped inside the spincast reel! Problems- old line,line twist,over or under sized line for reel,not enought weight"pressure"on line for it to keep contact with the pickup!

Injun

Related Q & A:

Just Added Q & A:

Find solution

For every problem there is a solution! Proved by Solucija.

  • Got an issue and looking for advice?

  • Ask Solucija to search every corner of the Web for help.

  • Get workable solutions and helpful tips in a moment.

Just ask Solucija about an issue you face and immediately get a list of ready solutions, answers and tips from other Internet users. We always provide the most suitable and complete answer to your question at the top, along with a few good alternatives below.