How Do I route power wires for a subwoofer amp in a 2006 Jeep Wrangler Rubicon?
-
I have the wiring, and the amp, and the subs....I decided that I want to keep a stereo system in during the winter months. Is there a place in the firewall to lead wires through to ...show more
-
Answer:
i have drilled holes threw firewalls before but they are there for a reason.. so what i would do is look on the top right or left corners under your hood and sometimes there will be little holes you could run them threw. if not try and pick a spot where you would be able to drill a hole with out damaging anything and where you can access if from inside your car. i had a system in my jeep and i drilled a hole on the top right corner of my hood (not the actual hood but underneath it) and i was able to pull it threw the door with a cloths hanger. then i pulled the carpeting up and drilled another hold and ran the wire under the carpet and down the length of my car into my trunk. very easy to do and looks professional. if you make it look good enough friends will start asking you wire their car. Best Of Luck
XZGBUNZC3KADS3W7FG6MMCS4XI at Yahoo! Answers Visit the source
Other answers
no don't run the power through the fuse box if you do so you will draw too much power through the fuse box's power wire and you will latterly melt the plastic coding on the wire and cause a fire, you use 6 Gage wire at the least to handle the load other wise the wire will over heat, not to mention you run the potential to Frye your electronics that are run through the fuse box it's self well to save time and mistakes in my car i just ran the wires through the engine compartment and than got a piece of steel tubing From Lowe's and secured it along side the body lip under the car than up through a drain hole on the under carriage of the car into the trunk, the most effective way so when you go to sell it you don't have all the holes and **** there, and you don't have to tare you all the carpet to get it in. it works! 3 years w/ 2 rockfords stage 2 and a 1600 punch amp.
mercury_marsh
I have the 2006 Rubicon and the subwoofer is in the right armrest. I also just had a power inverter installed and a CB, but I didn't watch, so I can't tell you where the power lines go. However, I think they took the power from the fuze box because everything goes off when I turn off the ignition.
Marcus R.
Related Q & A:
- How can I change my speakers in a Jeep Grand Cherokee limited?Best solution by Yahoo! Answers
- How can I power 4 speakers with a 2-channel amp?Best solution by Yahoo! Answers
- What is a good price for a 2005? Jeep Wrangler?Best solution by ChaCha
- How should I connect my wires to my amp?Best solution by Yahoo! Answers
- How do I get max power out of my amp?Best solution by Yahoo! Answers
Just Added Q & A:
- How many active mobile subscribers are there in China?Best solution by Quora
- How to find the right vacation?Best solution by bookit.com
- How To Make Your Own Primer?Best solution by thekrazycouponlady.com
- How do you get the domain & range?Best solution by ChaCha
- How do you open pop up blockers?Best solution by Yahoo! Answers
For every problem there is a solution! Proved by Solucija.
-
Got an issue and looking for advice?
-
Ask Solucija to search every corner of the Web for help.
-
Get workable solutions and helpful tips in a moment.
Just ask Solucija about an issue you face and immediately get a list of ready solutions, answers and tips from other Internet users. We always provide the most suitable and complete answer to your question at the top, along with a few good alternatives below.