Find solution
How to remove stereo out of 2006 Ford Explorer?

How to remove a stock stereo from a ford explorer?

  • Answer:

    would help to know the year..... 91-01 pull the fascia up after unbolting the screws that are around the radio (91-94 is basically covers half the dash, the 95-01s are just the center area) Pull radio with U-clips availabale at autozone and other places for cheap... insert till it clicks then pry outward on the clips and pull out... 02-06 just pull center area by digging it out and unbolt the 4 screws holding the radio in

QPA5DRXR4Y4Y54DOWROX63YD5I at Yahoo! Answers Visit the source

Was this solution helpful to you?

Other answers

You can get a tool from a garage or you can use two coat hangers to poke in the holes on the bottom of both sides.

Tracy Z

stock stereo can be removed by locating "2" small holes on either side of the faceplate then inserting "2" rods you can use clothes hangers which were cut and straightened . This releases the retaining locks and it will pull out then disconnect the obvious wiring ....good luck

pack23wolfden

Related Q & A:

Just Added Q & A:

Find solution

For every problem there is a solution! Proved by Solucija.

  • Got an issue and looking for advice?

  • Ask Solucija to search every corner of the Web for help.

  • Get workable solutions and helpful tips in a moment.

Just ask Solucija about an issue you face and immediately get a list of ready solutions, answers and tips from other Internet users. We always provide the most suitable and complete answer to your question at the top, along with a few good alternatives below.