Find solution
Where is the 2002 Nissan Altima speed sensor located?

Where does the 96 nissan altima crank sensor located?

  • where does the 96 nissan altima crank sensor located? does anyone know? error code is p0335 need to replace the sensor

  • Answer:

    As you are looking down at your engine, it should be to the right of the exhaust manifold under a hose, near where the trans mounts to the engine.

F3LLRR5VHVPIRBFQ6EARN74YPA at Yahoo! Answers Visit the source

Was this solution helpful to you?

Other answers

You have pretty good answers the sensor however is located in the bell housing of the transmission in front look straight down behind the radatior just to the right side of center facing rear of the car it has two wires and black plastic plug. One 10mm bolt holds it into the transmission's bell housing. Approx 4" long when removed.

John Paul

should be on driver side. Top of cylinder head on engine all data site tell you..

Mudd

Look directly beneath the radiator cap and next to the radiator hose you should see the connector for the crank position sensor. It take the signal off the flywheel and yes code P0335 indicates replace the crank sensor. To test it if you want is 432-528 ohms at 77 degrees F.

ocnwolf99

Related Q & A:

Just Added Q & A:

Find solution

For every problem there is a solution! Proved by Solucija.

  • Got an issue and looking for advice?

  • Ask Solucija to search every corner of the Web for help.

  • Get workable solutions and helpful tips in a moment.

Just ask Solucija about an issue you face and immediately get a list of ready solutions, answers and tips from other Internet users. We always provide the most suitable and complete answer to your question at the top, along with a few good alternatives below.