Find solution
What is the small hole in the casing of a Bic biro for?

My Skyteam 200cc pit bike chain jammed on the front sprocket and made a hole in the side of the engine casing?

  • Now that I have a hole in the side of my engine casing it rapidly leads a lot of oil, I've tried fixing it using Gun Gum and it never worked. I was going to try using Liquid Metal but quite sure that wont work either and it can't be welded... Do I replace the engine casing? If so, where do I get the right one for my Sky-team 200? Any help will be much appreciated. Please help, many thanks, Neal!

  • Answer:

    This is a job for JB Weld. Lay the bike on the side w/o the chain. Clean area with break cleaner and try not to get any epoxy in the engine. I would do a little at a time and give it time to cure before the next layer. If it doesn't work all your out is some time, oil and the cost of the epoxy. I would try and figure out if the chain stretched or was just out of adjustment.

Neal at Yahoo! Answers Visit the source

Was this solution helpful to you?

Other answers

try to find the parts on line, you can also try jb weld. I used it on the case of my quad when that happened and it worked like a champ

Jak

Yes you will need to replace it From - China probably

Timbo is here

Related Q & A:

Just Added Q & A:

Find solution

For every problem there is a solution! Proved by Solucija.

  • Got an issue and looking for advice?

  • Ask Solucija to search every corner of the Web for help.

  • Get workable solutions and helpful tips in a moment.

Just ask Solucija about an issue you face and immediately get a list of ready solutions, answers and tips from other Internet users. We always provide the most suitable and complete answer to your question at the top, along with a few good alternatives below.