Find solution
Aftermarket Car Alarm Help?

Help!! My Clifford Alarm is going crazy and my car won't start!!?

  • Hello, This morning I unlocked my car with my alarm remote as usual and when I put the key into my ignition my car would not start and the alarm started going crazy. I had to disconnect the alarm from the battery and the noises stopped. I connected my battery Without the alarm cable and my car has no power what so ever but if I connect my alarm cable back to the battery the alarm goes off again and my dash lights turn on. Can someone please help me! I just started a new job and could not make it into work today because of this problem. I drive a 2003 Ford expedition and it has a Clifford alarm 590.2x

  • Answer:

    The reason that it work start is because it has a relay that interrupts the starter and most likely you have a bad relay or the main controller is bad. If you are unable to get it resolved then locate the relay and disconnect the two wires going to the starter and splice them together, this way it will start.

juicy j at Yahoo! Answers Visit the source

Was this solution helpful to you?

Other answers

Take the fuse out and put it back in, that might work

Kevin

Related Q & A:

Just Added Q & A:

Find solution

For every problem there is a solution! Proved by Solucija.

  • Got an issue and looking for advice?

  • Ask Solucija to search every corner of the Web for help.

  • Get workable solutions and helpful tips in a moment.

Just ask Solucija about an issue you face and immediately get a list of ready solutions, answers and tips from other Internet users. We always provide the most suitable and complete answer to your question at the top, along with a few good alternatives below.