Find solution
How cold can it be outside to work with fiberglass resin?

Would this resin and hardener be good for fiberglass?

  • West systems 105 epoxy resin and 205 or 206 hardener http://www.westsystem.com/ss/#1.1 I am going to be using this for carbon fiber work and wanted to know if I could use it for fiberglass as well?

  • Answer:

    West System will work great with fiberglass. I have used West System for repair of fiberglass and for new fiberglass work too. Great Stuff!

BMXican at Yahoo! Answers Visit the source

Was this solution helpful to you?

Other answers

It will be great for fiberglass.... Much better then Polyester. You will have a stronger, lighter, and less brittle piece. If you get it on your skin, vinegar works great to get it off. It will take longer to cure. Don't remove it from your mould for at least 3 days. It takes longer, but it is a lot better piece and is worth the wait.

lyderslim

It is better than polyester for sure. The different hardeners only effect the speed of set. It will be very strong and flexible. Just cleaned up after using some to make a new hatch. Keep off skin!! Good luck.

ricsudukai

Related Q & A:

Just Added Q & A:

Find solution

For every problem there is a solution! Proved by Solucija.

  • Got an issue and looking for advice?

  • Ask Solucija to search every corner of the Web for help.

  • Get workable solutions and helpful tips in a moment.

Just ask Solucija about an issue you face and immediately get a list of ready solutions, answers and tips from other Internet users. We always provide the most suitable and complete answer to your question at the top, along with a few good alternatives below.