Does the Focal amp run the Focal speakers well?

How do I rewire my speakers to my headunit? I want to remove the amp and just run it off the headunit.?

  • I bought a used car that has a full sound system (head unit, speakers, amp, and subwoofer). The amp is broken and now my speakers and my subwoofer is acting up (woofer is silent, and my speakers stop working at high volume). Also, my headunit doesnt work very well (the CD gets stuck), so I decided to replace the headunit and the speakers, but remove the subwoofer and the amp. I understand that the amp is connected to the speakers, so once I remove the amp, how do I reconnect the speakers back to the headunit? Thank you for reading this and for your time.

  • Answer:

    Well, first it sounds as though whoever put the amp in in the first place did it wrong. If it shut off at high volume, it was probably all wired for a low impedance that what the amp could handle. As for the rewiring. Find the + and - leads for each spk (assuming theres only 4) and connect them to the the corresponding + and - leads out of the head, relating to their position in the vehicle. Most people leave the factory speaker wiring in the vehicle, or only cut off a small amount, so replacing the wires should be as simple as obtaining a color code or diagram for your vehicle and attaching the proper wires where they are needed.

sekivain at Yahoo! Answers Visit the source

Was this solution helpful to you?

Just Added Q & A:

Find solution

For every problem there is a solution! Proved by Solucija.

  • Got an issue and looking for advice?

  • Ask Solucija to search every corner of the Web for help.

  • Get workable solutions and helpful tips in a moment.

Just ask Solucija about an issue you face and immediately get a list of ready solutions, answers and tips from other Internet users. We always provide the most suitable and complete answer to your question at the top, along with a few good alternatives below.