How to install a sub in a sub box?

I need the best way to install a 600 watt sony xplod amp to a 1000 watt peak 500 rms legacy dvc 10 inch sub?

• i need the best way to install a 600 watt sony xplod amp to a 1000 watt peak 500 rms legacy dvc 10 inch sub in a reg cab silverado in a truck box.

• Answer:

  You can try parallel the voice coils. If each is 2 ohm on the sub it will result in a 1ohm load so make sure that your amp can take the load if not u will fry the amp. Parallel means hookin up + to + and - to- on the voice coils then running it to ur amp. If ur amp can't take the 1 ohm load then do the voice coils in series which means going from the amp + to the + on the sub then - amp to - sub then wire the 2 remaining coils together but make sure its one coil from each like say positive from coil 1 and negative from coil 2. If not u will cause damage to the amp. The first diagram is parallel and the 2nd one is series it all depends on the ohm ur amp can support. http://www.cardomain.com/shop/wooferwizard.pl?num_of_subs=1&impedance_of_subs=2ohm_dvc&x=119&y=12