Find solution
How to wire 2 subwoofers inverted?

How to wire 2 dual 4ohm subwoofers to 2ohms?

Matthew at Yahoo! Answers Visit the source

Was this solution helpful to you?

Other answers

These are your options. If its DVC subs (dual voice coils), or SVC (single voice coil) DVC: 1 ohm or 4 ohm load: http://www.the12volt.com/caraudio/woofer_configurations.asp?Q=2&I=42 SVC: 2 Ohm or 8 ohm: http://www.the12volt.com/caraudio/woofer_configurations.asp?Q=2&I=41 Ok saw now you got the DVC.. Im afraid you cant get 2 ohm load then. But you can get 4 ohm load with DVC as link 1 gives. If bridging your subs, you can only series the sub coils, and parallel subs together to amp (series/parallel)(at 4 ohm)).

kaeksen

bridge the subs into the amp. just connect the wires from the subs together an put them in the same pos an neg in the amp

Justin

Related Q & A:

Just Added Q & A:

Find solution

For every problem there is a solution! Proved by Solucija.

  • Got an issue and looking for advice?

  • Ask Solucija to search every corner of the Web for help.

  • Get workable solutions and helpful tips in a moment.

Just ask Solucija about an issue you face and immediately get a list of ready solutions, answers and tips from other Internet users. We always provide the most suitable and complete answer to your question at the top, along with a few good alternatives below.