How do I wire up two separate amps in my car?

How would I wire my subs and amps?

  • I have 3 alpine 12" type r's and I want to get two HIFONICS BRUTUS BXi1610D 1600W Car Amps, but I am not sure how I would wire it all together. Any suggestions?

  • Answer:

    the Type R's are only rated for 500 watts RMS. so why do you want 3200 watts for 3 woofers that require 500 watts (1500 total). Next why do you want to power 3 amplifiers with 2 amps that aren't strappable? you'd be better off going with 4 woofers for 2 amps. Or just one amp that puts out more power than the 1600D. Hifonics makes one that puts out 3000 watts I think. Finally you didn't tell us whether your woofers are dual 4 ohm or dual 2 ohms. so we can't help you with any wiring at all. http://www.the12volt.com/caraudio/woofer_configurations.asp But if you go to that site you'll be able to check out different wiring configurations based on what you have.

Ben J at Yahoo! Answers Visit the source

Was this solution helpful to you?

Related Q & A:

Just Added Q & A:

Find solution

For every problem there is a solution! Proved by Solucija.

  • Got an issue and looking for advice?

  • Ask Solucija to search every corner of the Web for help.

  • Get workable solutions and helpful tips in a moment.

Just ask Solucija about an issue you face and immediately get a list of ready solutions, answers and tips from other Internet users. We always provide the most suitable and complete answer to your question at the top, along with a few good alternatives below.