What is the best amplifier chip available?

Can I safely assume 100% that it's my amplifier's problem?

• The basics of my problem: I receive a new amplifier from ebay after my old amplifier broke on the road. The new amplifier, once hooked up correctly can't power my subwoofer at all. I begin to wonder if perhaps my old amp actually worked after all and it was something else that was the problem. After enormous amounts of trial and error I'm still unsure if it's safe to assume 100% that the new amplifier is the problem. I definitely don't want to go through an ebay return if I don't have to. I hooked it up to a small 6 1/2 inch door speaker and was surprised to get a very small output from it. It was low pitched and very soft even though the amplifier is 400 watts rms at 4 ohms (which btw both my subwoofer enclosure and door speaker are @ 4ohms) and the amplifier was at maximum sensitivity, which should have resulted in one very fried door speaker, but it didn't. I also tried various other things which I cover in the details below: Is there anything remaining that hasn't been tested one way or another conclusively? Subwoofers (tested on a door speaker which is known to work with head unit outputs of only 10 watts or so and only got tiny sounds from it) RCA cables (tested using a portable DVD player and separate RCA cables, same problem with the door speaker and the subwoofer) Head unit (tested using another head unit and same problem, also this head unit was the one I was using previously and it worked with my old amp when I took it out) Subwoofer wires (used the same wire on the door speakers and it's a see through 10 gauge high output wire with no problem areas) 1X 60A AGC glass fuse near battery (was taken out and the wire bonded together without the fuse resulting in the same problem) 3X 40A plastic fuses on the amp (They appear to be intact, I checked each of them closely although I need a voltmeter to confirm) 1X 10A fuse on head unit (Connected with copper wire (bypassing the fuse) and tried it to be sure resulting in the same problems) Power cable + 8 gauge from battery (sparks against the frame just like it used to -- very violently) Power cable - 8 gauge (connected to a new spot that's 100% bare from paint and then tightened excessively to ensure contact) Battery (Well it starts the car fine, that should be enough) The amplifier has enough energy from the remote and power cables to turn the power protection light to green also, so I know it's getting at least some power and the remote cable is in all likelihood working as well. Once again I'm at a loss. If the voltmeter picks up 12v or more between the terminals and 2v on the signal cables later today can I safely assume it's the amplifier? Or what else can I do to be sure? It's been driving me crazy over the last 3 or 4 days.

• Answer:

  Since it doesn't sound like you have the proper equip. you can pull the amp and take to a stereo shop and have it checked out. I think I would try another set of RCA's. Sorry but your description of RCA cables left me a Little confused. Did you try 2 different RCA's? Do you have an extra sub not being used or have a buddy that got one around. Even a home stereo sub will work..But all in all nothing that really says anything is working properly, it could be the outputs of the HU. I've bought alot of stereo stuff on eBay and never had a prob. with any of it.